Section 3: Conformity assessment procedures applicable to each category of machinery, work equipment or personal protective equipment

With the exception of those listed in article R. 4313-78, machinery is subject to the conformity assessment procedure with internal control of manufacture. Agricultural or forestry tractors and their separate technical units, systems or components are subject to the EU type-approval or national type-approval procedures defined respectively by Regulation (EU) No 167/2013 of the European Parliament and of the Council of 5 February 2013 on type-approval and market surveillance of…

Where the machine is referred to in Article R. 4313-78 and is manufactured in accordance with the harmonised standards referred to in Article L. 4311-7, and provided that these standards cover all the relevant technical rules, the manufacturer shall apply one of the following procedures: 1° The conformity assessment procedure with internal control of manufacture; 2° The EC type-examination procedure with internal control of manufacture; 3° the full quality assurance…

Where the machine is referred to in Article R. 4313-78 and is not manufactured in accordance with the harmonised standards referred to in Article L. 4311-7 or if the harmonised standards do not cover all the relevant technical rules, the manufacturer shall apply one of the following procedures: 1° The EC type-examination procedure and internal production control; 2° The full quality assurance procedure.

New machines or machines considered as new which are subject either to the procedures defined in article R. 4313-76 or to those defined in article R. 4313-77, are as follows: 1° Circular saws (single- or multiblade) for working with wood and material with similar physical characteristics or for working with meat and material with similar physical characteristics, of the following types : (a) Sawing machinery with one or more fixed…

An assembly of machinery consisting of the assembly of a machine or tractor with interchangeable equipment is not required to satisfy the conformity certification procedure applicable to that assembly if the two constituent parts are compatible with each other and if each of those parts has satisfied the conformity assessment procedure applicable to it.